DELL Inspiron 5370 RAM upgrade specifications
DELL Inspiron 5000 Series Model 5370 supports DDR4-SDRAM memory upgrades with maximum capacity of 32 GB. The laptop features 2x SO-DIMM slots for memory expansion. Compatible RAM operates at 2400 MHz frequency using SO-DIMM form factor. Memory upgrade specifications enable users to expand existing RAM capacity up to the maximum supported 32 GB configuration. Current and future memory installations must match the DDR4-SDRAM standard and SO-DIMM physical specifications for proper compatibility with this DELL Inspiron 5370 model.
Memory Upgrade Specifications
| Specification | Value |
|---|---|
| Memory slots | 2x SO-DIMM |
| Form factor | SO-DIMM |
| Memory type | DDR4-SDRAM |
| Frequency | 2400 MHz |
| Maximum RAM | 32 GB |
| Voltage | 1.2V |
| Number of pins | 260-pin |
| Interface | PC4 |
| PC Speed Rating | PC4-2400 (PC4-19200) |
| Bandwidth | 19.2 GB/s |
| Laptop Release date | 07 March 2018 |
Additional Notes
- The 2400 MHz frequency specification indicates PC4-19200 modules are required for native speed operation.
- Higher frequency modules such as 2666 MHz or 3200 MHz will downclock to 2400 MHz when installed in this system.
- SO-DIMM form factor restricts module selection to laptop-specific memory modules, excluding standard desktop DIMM modules.
- The dual-channel architecture requires matched pairs of identical capacity modules for optimal memory bandwidth utilization.
- Single module installation will operate in single-channel mode, reducing memory subsystem throughput by approximately 50 percent.
- The 32 GB maximum capacity constraint limits configurations to either 2x16 GB or lower density combinations.
- Installing 2x32 GB modules will exceed system addressing capabilities regardless of physical installation success.
- Mixed capacity configurations such as 8 GB plus 16 GB will function but operate both modules in flex mode with asymmetric channel bandwidth.
- DDR3 or DDR3L modules are physically incompatible due to different notch positions despite similar SO-DIMM form factor.
- Voltage requirements are fixed at 1.2V for DDR4, eliminating low-voltage variant considerations present in DDR3 systems.
- CAS latency variations at 2400 MHz such as CL15, CL16, or CL17 will affect memory access timing but remain compatible.
- The Inspiron 5370 chassis design typically requires bottom panel removal for memory slot access rather than dedicated service doors.
- Unbuffered non-ECC modules are the standard requirement for consumer laptops, rendering registered or ECC memory incompatible.
- Memory bandwidth peaks at 38.4 GB/s in dual-channel configuration, establishing the maximum data transfer rate ceiling.
- Thermal constraints in the thin Inspiron 5370 chassis may require modules without tall heat spreaders for proper clearance.