ASUS Vivobook TP501UQ-CJ135T RAM upgrade specifications
ASUS Vivobook Flip TP501UQ-CJ135T memory upgrade specifications detail DDR4-SDRAM compatibility with maximum RAM capacity of 12 GB. The laptop features one SO-DIMM slot for memory expansion, operating at 2133 MHz frequency. Upgrade configuration combines on-board memory with SO-DIMM slot architecture. Compatible DDR4 memory modules enable capacity expansion beyond factory specifications.
Memory Upgrade Specifications
| Specification | Value |
|---|---|
| Memory slots | 1x SO-DIMM |
| Form factor | On-board + SO-DIMM |
| Memory type | DDR4-SDRAM |
| Frequency | 2133 MHz |
| Maximum RAM | 12 GB |
| Voltage | 1.2V |
| Number of pins | 260-pin |
| Interface | PC4 |
| PC Speed Rating | PC4-2133 (PC4-17064) |
| Bandwidth | 17.1 GB/s |
| Laptop Release date | 24 October 2017 |
Additional Notes
- The presence of on board memory indicates that a portion of the system RAM is non removable and cannot be replaced or upgraded if a chip failure occurs.
- Dual channel performance benefits remain limited to the capacity matched between the 4 GB soldered module and the first 4 GB of any installed SO DIMM expansion.
- The 12 GB maximum capacity ceiling restricts the device to a single 8 GB module in the available slot because the architecture does not support 16 GB or 32 GB densities.
- Installing high speed 2400 MHz or 3200 MHz modules will result in automatic downclocking to 2133 MHz to maintain synchronization with the fixed speed of the on board chips.
- The single slot configuration prevents a traditional dual stick replacement strategy necessitating the disposal of the existing SO DIMM to increase total capacity.
- Asymmetrical memory configurations exceeding 8 GB total will operate in flex mode where only the synchronized portion of the memory pool retains peak bandwidth efficiency.
- Technical constraints on the motherboard chipset prevent the utilization of low latency XMP profiles or manual timing adjustments in the BIOS environment.
- Physical access to the SO DIMM slot requires the removal of the entire lower chassis assembly which may involve internal clips or hidden screws beneath rubber feet.