ASUS ROG GL503VM-ED110T RAM upgrade specifications

ASUS GL503VM-ED110T ASUS GL503VM-ED110T ASUS GL503VM-ED110T ASUS GL503VM-ED110T ASUS GL503VM-ED110T

ASUS ROG Strix GL503VM-ED110T memory upgrade specifications include two SO-DIMM slots supporting DDR4-SDRAM modules operating at 2400 MHz. The laptop accommodates a maximum RAM capacity of 32 GB total. Compatible memory modules must feature SO-DIMM form factor specifications. Upgrade options allow installation of additional DDR4 memory to enhance system performance and multitasking capabilities. Current specifications and slot configuration enable flexible memory expansion within the 32 GB maximum limit. DDR4-2400 specifications ensure compatibility with the gaming-focused ROG Strix platform architecture.

Memory Upgrade Specifications

SpecificationValue
Memory slots2x SO-DIMM
Form factorSO-DIMM
Memory typeDDR4-SDRAM
Frequency2400 MHz
Maximum RAM32 GB
Voltage1.2V
Number of pins260-pin
InterfacePC4
PC Speed RatingPC4-2400 (PC4-19200)
Bandwidth19.2 GB/s
Laptop Release date05 December 2017

Additional Notes

  • Dual channel architecture requires matching memory capacities and timings across both slots to achieve maximum theoretical memory bandwidth.
  • Physical access to the motherboard for installation requires removing the entire chassis base plate due to the lack of a dedicated quick access hatch.
  • The chipset imposes a hard upper limit on addressable capacity meaning the motherboard will not POST if 32 GB modules are utilized in a single slot.
  • Installing modules with frequencies exceeding 2400 MHz results in automatic downclocking to remain within the hardware stability profile of the motherboard.
  • Memory modules must utilize 1.2V low voltage standards to ensure compatibility with the power delivery system of the laptop.
  • Mixing Rank 1 and Rank 2 density modules leads to secondary timing misalignment which increases system latency during heavy computational loads.
  • Upgrading beyond the factory configuration necessitates the use of unbuffered non-ECC modules as buffered or registered memory is electrically incompatible.
  • Reaching the 32 GB threshold requires the replacement of any pre-installed 4 GB or 8 GB modules because only 2 slots are physically present on the circuit board.