HP Probook 645 G2 RAM upgrade specifications

HP Probook 645 G2 RAM upgrade specifications include two SO-DIMM memory slots supporting DDR3L-SDRAM at 1600 MHz frequency. Maximum memory capacity reaches 16 GB total. Compatible memory modules must match SO-DIMM form factor specifications for proper installation in upgrade slots. Specifications indicate DDR3L-SDRAM as the required memory type for this HP Probook 600 series model.

Additional Notes

• The dual channel configuration requires two matched modules to double the available memory bandwidth and optimize integrated graphics performance.
• Use of standard 1.5V DDR3 modules will result in a failure to boot because the motherboard chipset only supports the 1.35V low voltage requirement.
• Accessing the SO-DIMM slots on the HP Probook 645 G2 necessitates removing the bottom service panel which may involve specialized security screws depending on the regional subclass.
• Installing a single 16 GB module will result in a non-functional state as the 16 GB maximum capacity is restricted to a 8 GB per slot density limit.
• Mixing modules with different latency ratings will force the system to default to the slowest timing profile available across both slots.
• The physical architecture of the internal chassis limits memory height to standard SO-DIMM profiles prohibiting the use of modules with integrated heat spreaders.
• Upgrading beyond the factory default capacity does not void the hardware warranty provided no physical damage occurs to the internal plastic clips during the installation process.