MSI Gaming GL63 8SD-277NL RAM upgrade specifications

MSI GL63 8SD-277NL MSI GL63 8SD-277NL MSI GL63 8SD-277NL MSI GL63 8SD-277NL MSI GL63 8SD-277NL

The MSI GL63 8SD-277NL Gaming Series laptop features DDR4-SDRAM memory upgrade specifications with 2x SO-DIMM slots supporting a maximum capacity of 32 GB RAM. Compatible memory modules operate at 2666 MHz frequency using SO-DIMM form factor. Upgrade specifications allow for expanded RAM capacity to enhance system performance on this MSI GL Gaming Series model.

Memory Upgrade Specifications

SpecificationValue
Memory slots2x SO-DIMM
Form factorSO-DIMM
Memory typeDDR4-SDRAM
Frequency2666 MHz
Maximum RAM32 GB
Voltage1.2V
Number of pins260-pin
InterfacePC4
PC Speed RatingPC4-2666 (PC4-21328)
Bandwidth21.3 GB/s
Laptop Release date16 October 2019

Additional Notes

  • The MSI GL63 8SD-277NL accepts only SO-DIMM form factor modules, making standard desktop DIMM memory physically incompatible with the system.
  • Each memory slot supports a maximum of 16 GB per module to reach the 32 GB system ceiling.
  • Installing modules rated above 2666 MHz will result in automatic downclocking to match the supported frequency limit.
  • Mixing modules with different speeds forces all installed memory to operate at the frequency of the slowest module.
  • DDR3 or DDR3L modules are electrically incompatible and will not fit due to different notch positions in the SO-DIMM connector.
  • Single-channel configuration occurs when only 1 module is installed, reducing memory bandwidth by approximately 50 percent compared to dual-channel operation.
  • Accessing the SO-DIMM slots typically requires removing the bottom panel, which may void manufacturer warranty if seals are broken.
  • Non-matching capacities across the 2 slots still enable dual-channel mode, but only for the capacity matched on both modules.
  • CAS latency variations between modules may cause stability issues, though the system will attempt to reconcile timings automatically.
  • ECC memory features are not supported, requiring unbuffered non-ECC SO-DIMM modules for successful operation.
  • Operating voltage must be 1.2V standard for DDR4, as higher voltage modules designed for overclocking may cause boot failures.