MSI Prestige PS42 8M-223UK RAM upgrade specifications

MSI PS42 8M-223UK MSI PS42 8M-223UK MSI PS42 8M-223UK MSI PS42 8M-223UK MSI PS42 8M-223UK

MSI Prestige PS42 8M-223UK laptop RAM upgrade specifications indicate DDR4-SDRAM memory compatibility with single SO-DIMM slot configuration. Maximum memory capacity reaches 16 GB through compatible upgrade modules. Operating frequency specifications are 2400 MHz. Upgrade slots support DDR4 SO-DIMM form factor modules. Specifications confirm upgrade compatibility with DDR4 memory standard operating at designated frequency parameters for the PS42 8M-223UK model within Prestige series.

Memory Upgrade Specifications

SpecificationValue
Memory slots1x SO-DIMM
Form factorSO-DIMM
Memory typeDDR4-SDRAM
Frequency2400 MHz
Maximum RAM16 GB
Voltage1.2V
Number of pins260-pin
InterfacePC4
PC Speed RatingPC4-2400 (PC4-19200)
Bandwidth19.2 GB/s
Laptop Release date24 October 2018

Additional Notes

  • The single SO-DIMM slot architecture prevents dual-channel memory operation, limiting memory bandwidth to approximately 19.2 GB/s compared to 38.4 GB/s available in dual-channel configurations.
  • Replacing the existing module requires complete removal of the current RAM, as no expansion slot exists for adding supplementary capacity.
  • The 16 GB maximum capacity constraint suggests motherboard chipset or BIOS limitations that prevent recognition of higher-density modules.
  • DDR4-2400 represents a base JEDEC standard speed, indicating the system likely does not support XMP profiles or higher frequency modules may downclock to 2400 MHz.
  • Graphics performance in integrated GPU scenarios will experience reduced frame rates due to single-channel memory bandwidth restrictions, particularly in memory-intensive workloads.
  • The SO-DIMM form factor requires bottom panel removal for access, as this form factor typically resides underneath the chassis rather than through dedicated service doors.
  • Mixing different capacity modules is not applicable here, eliminating concerns about asymmetric channel configuration or rank mismatches.
  • Memory latency specifications (CL timings) become more critical in single-channel setups, as lower CAS latency modules can partially offset bandwidth limitations.
  • The 2400 MHz speed corresponds to PC4-19200 module designation, which must match when sourcing replacement memory.
  • Voltage requirements default to 1.2V standard DDR4 specification, as no low-voltage or overclocking variants are supported at this frequency tier.