MSI Bravo 15 A4DDR-023 RAM upgrade specifications

MSI 15 A4DDR-023 MSI 15 A4DDR-023 MSI 15 A4DDR-023 MSI 15 A4DDR-023 MSI 15 A4DDR-023

The MSI Bravo 15 A4DDR-023 features DDR4-SDRAM memory upgrade specifications with two SO-DIMM slots supporting maximum capacity of 64 GB. Compatible RAM operates at 3200 MHz frequency and utilizes SO-DIMM form factor. Specifications indicate memory slots available for upgrades to enhance system performance. Maximum RAM capacity of 64 GB represents total supported memory across both slots. DDR4 memory type ensures compatibility with processor architecture. Frequency rating of 3200 MHz reflects operational speed specifications for this laptop model's memory subsystem.

Memory Upgrade Specifications

SpecificationValue
Memory slots2x SO-DIMM
Form factorSO-DIMM
Memory typeDDR4-SDRAM
Frequency3200 MHz
Maximum RAM64 GB
Voltage1.2V
Number of pins260-pin
InterfacePC4
PC Speed RatingPC4-3200 (PC4-25600)
Bandwidth25.6 GB/s
Laptop Release date19 May 2020

Additional Notes

  • Dual channel mode is only achievable when installing pairs of matching modules to maximize communication bandwidth between the processor and temporary storage.
  • The 64 capacity limit necessitates removing preinstalled modules because no additional unoccupied slots exist for expansion.
  • Operating at 3200 requires modules with specific JEDEC profiles to avoid downclocking to lower base speeds determined by the memory controller.
  • The MSI Bravo 15 A4DDR-023 utilizes a SODIMM architecture which precludes the use of standard desktop DIMM hardware due to physical pin density and length variations.
  • High density 32 modules may generate more heat within the chassis requiring adequate thermal management during sustained heavy workloads.
  • Latency performance depends on the CAS timing compatibility with the existing BIOS firmware settings since manual voltage adjustments are often restricted in this motherboard category.
  • Installation of non JEDEC compliant overclocking kits might result in system instability if the hardware cannot negotiate the required timings at 1.2 volts.